08-27-2023, 04:27 PM | #1 |
Registered
0
Rep 4
Posts |
Flashing HU_entry connection problem
Hello,
I have an f20 withsmall screen Hu_entry that I would like to flash withenet cable and esys 3.33 and full psdzdata. Few minutes after tal processing start there is problem to connect to hu_entry after boot loader modus displayed on screen. I tried initial connection with gateway url or via vin, i have the same error. I tried to disable parallele programming but it's the same. I also tried with static ip. I then tried with dhcp server but i can't get initial connection. Here is the log: AL execution started. VCM Update: VCM-Update is deactivated. VCM will not be updated. [C197] ExecutionID=2023/08/27-21:06:43.650 [] prepareTALExecution started [PROGRESS] [] prepareTALExecution finished [PROGRESS] [] prepareVehicleForFlash started [PROGRESS] [] prepareVehicleForFlash finished [PROGRESS] MCDDiagService<id=285200, job=com.bmw.psdz.jobs.common.MCD3_ActivateProgMode Cascade, service=RDBI_IPCONF - ReadDataByIdentifier IPConfig, description=error: positive response with negative content: IP 0.0.0.0 not valid, link=HU_ENTRY_63_ETHERNET> [DIAGSERVICE] [] Activate programming mode was not successful for: ECUId:HU_ENTRY_0x63 [WARN] [] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [WARN] [HU_ENTRY - 63] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [THROWABLE] [] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [WARN] [] finalizeVehicleFlash started [PROGRESS] [] finalizeVehicleFlash finished [PROGRESS] [] prepareVehicleForCoding started [PROGRESS] [] prepareVehicleForCoding finished [PROGRESS] [] finalizeVehicleCoding started [PROGRESS] [] finalizeVehicleCoding finished [PROGRESS] [] finalizeTALExecution started [PROGRESS] [] finalizeTALExecution finished [PROGRESS] TAL execution finished [TAL_EXECUTION_FINISHED] TAL-Execution finished with status: "FinishedWithError". [C207] TAL execution finished. Duration: "2min 38s". [C206] Read SVT after TAL execution started. Read SVT after TAL execution finished. Thank you for your help |
Post Reply |
Bookmarks |
|
|