08-27-2023, 05:36 PM | #1 |
New Member
0
Rep 6
Posts |
High Beam Assist Retrofit Issue
Hi all, need a bit of help.
Today I have used a thread on the F30 page to retrofit high beam assist (and cruise control) to my car. The labour itself was pretty easy (thanks to the thread), and I am having it coded in the week but wanted to get the labour done at the weekend. I assumed that I would be able to drive the car until then without any issues, just obviously without the two retrofits working. However, it has backfired. Nothing on the stalks or steering wheel works, and the wipers are permanently on. I have checked the fuses in the front and the FEM to check if any had blown, which they haven't. Is this just because the new stalks haven't been coded and they will not work at all? I assumed (perhaps wrongly) that it would work as before, as I have seen people retrofit cruise control and the limiter still works as normal until it is coded to the car. Or am I looking at something more problematic, like the new stalks not working or worse a module which has been fried? Any suggestions/insight would be really welcome! |
Post Reply |
Bookmarks |
|
|