[Rocky2go556]

Hello,

I have an f20 withsmall screen Hu_entry that I would like to flash withenet cable and esys 3.33 and full psdzdata.

Few minutes after tal processing start there is problem to connect to hu_entry after boot loader modus displayed on screen.

I tried initial connection with gateway url or via vin, i have the same error. I tried to disable parallele programming but it's the same.

I also tried with static ip. I then tried with dhcp server but i can't get initial connection.


Here is the log:

AL execution started.
VCM Update: VCM-Update is deactivated. VCM will not be updated. [C197]
ExecutionID=2023/08/27-21:06:43.650
[] prepareTALExecution started [PROGRESS]
[] prepareTALExecution finished [PROGRESS]
[] prepareVehicleForFlash started [PROGRESS]
[] prepareVehicleForFlash finished [PROGRESS]
MCDDiagService<id=285200, job=com.bmw.psdz.jobs.common.MCD3_ActivateProgMode Cascade, service=RDBI_IPCONF - ReadDataByIdentifier IPConfig, description=error: positive response with negative content: IP 0.0.0.0 not valid, link=HU_ENTRY_63_ETHERNET> [DIAGSERVICE]
[] Activate programming mode was not successful for: ECUId:HU_ENTRY_0x63 [WARN]
[] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [WARN]
[HU_ENTRY - 63] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [THROWABLE]
[] ECUId:HU_ENTRY_0x63 not accessible cause could not be switched to parallel programming mode [WARN]
[] finalizeVehicleFlash started [PROGRESS]
[] finalizeVehicleFlash finished [PROGRESS]
[] prepareVehicleForCoding started [PROGRESS]
[] prepareVehicleForCoding finished [PROGRESS]
[] finalizeVehicleCoding started [PROGRESS]
[] finalizeVehicleCoding finished [PROGRESS]
[] finalizeTALExecution started [PROGRESS]
[] finalizeTALExecution finished [PROGRESS]
TAL execution finished [TAL_EXECUTION_FINISHED]
TAL-Execution finished with status: "FinishedWithError". [C207]
TAL execution finished. Duration: "2min 38s". [C206]

Read SVT after TAL execution started.
Read SVT after TAL execution finished.


Thank you for your help