01-30-2024, 03:30 AM | #1 |
Registered
0
Rep 1
Posts |
![]()
Hi All,
2016 F20 M140 8AT. Downpipe (wagner sports cat) and custom tune was done about 5 years ago now. ~85k kms on the odo. Had a P0366 fault code so replaced the exhaust camshaft position sensor. Cleared fault codes. Fault code appears to be gone now. Start car and let it idle and after cold start it gets lumpy, shows a drivetrain malfunction warning and then stalls. If i switch to neutral when i stop and keep the revs above 1k the car seems fine. Haven’t given it the boot but if i keep the revs up the drivetrain warning doesn't come up and it feels like it has sufficient power. No fault codes appear to come up with my primitive scanning tools. Don’t want to drive it in this state. Does anyone have any suggestions to try or it’ll be a call to the stealership tomorrow to see when they can look at it. Thanks! |
Post Reply |
Bookmarks |
|
|