Drivetrain error and now idrive failed
So we've had our 2014 116D for a couple of years and it's been brilliant.
Week before last on ignition it flagged up a Drivetrain error, which then cleared almost instantly.
This week, it does it on every start up, but still clears instantly, plugged BimmerLink into it and it said:
Central gateway module = 1 error
801C20: Central fault memory full
Motor electronics = 2 errors
252500: Boost pressure actuator, control: interruption
297A00: Boost pressure actuator, control: control signal boost pressure actuator implausible
Today, misses went out in it again and now the idrive is dead, just stuck on the BMW logo, then reboots itself in an endless loop.
Now I am guessing that the boost actuator fault is likely to be the intake manifold sensor from the research I've done so far? I have ordered a new sensor (13628637896 - coming today/tomorrow) but the idrive going down at almost the same time? This seems a little odd to me, I'm new to BMW, but not new to stripping stuff apart and butchering it before taking it to a garage; so wondered if any of you kind peeps might be able to shed some light on this, or if I am barking up the wrong tree completely.
Last 7 VIN: P582412
|