View Single Post
      08-05-2020, 03:16 PM   #25
Efthreeoh
General
United_States
16946
Rep
18,578
Posts

Drives: The E90 + Z4 Coupe & Z3 R'ster
Join Date: May 2012
Location: Virginia

iTrader: (0)

Quote:
Originally Posted by GuidoK View Post
I don't think they're outlawed. Lots of (most?) semitruck/bus service stations use pits.
This is of course because it's not so easy to lift a 10+ tonne vehicle as it is to lift a car.

Also a pit is safer in lots of situations compared to a lift.
A lift can collapse, a vehicle can fall from a lift, and, in this instance, the bushings have to be torqued in the riding position: If you want to achieve that on a lift you have to put a lot of pressure under the wheel while the car is on the lift. That is a very dangerous situation.
A commercial 2-post lift if correctly installed is not going to collapse even after 50 years. All certified lifts have safety locks.

To torque suspension bolts, I've simply used my under-hoist transmission jack under the wheel to load the suspension (at the corner of the car) where the torque sequence is required to set the bushings at the correct position. I just lift the corner of the car off the lift arm pad a few millimeters. No danger in using that technique.
Appreciate 0