05-21-2015, 04:51 PM | #1 |
Registered
0
Rep 4
Posts |
Auto Stop/Start Question.
I have a three month old 116d EfficientDynamics Business (manual transmission) & since it was delivered the warning light for the auto stop/start system comes on every time the car comes to a halt. I also get the display to put the car into neutral at the same time, which does cause the engine to stop. So the car can do the auto stop/start cycle even though the warning light tells me it cannot do so.
Has anyone else had a similar issue? Any advice would be greatly appreciated. |
05-22-2015, 10:18 AM | #3 |
Registered
0
Rep 4
Posts |
Yes, if I put the car into neutral the engine does stop. But I still get an auto start/stop unavailable warning until I do so. The photo below shows what I mean, the car is asking to be put into neutral but also shows start/stop as unavailable even though the engine shuts off, & starts up again, like it should. I am wondering if this is the case for all manual F20s.
|
Appreciate
0
|
05-22-2015, 10:57 AM | #6 |
Registered
0
Rep 4
Posts |
If you press the button for the on-board computer it cycles through the displays. This one is the Eco Pro bonus range & the gauge at the right shows energy recuperation etc.
|
Appreciate
0
|
05-23-2015, 05:34 AM | #7 |
Colonel
1077
Rep 2,357
Posts |
haha thats a little funny. could be a software bug - everything sound ok. I would not worry - ask your dealer next time you go
__________________
M135i 8AT PWG, MHD, Pure Stage2, WMI via Torqbyte CM5-LT, Custom tuned by PureBoost
(A Dane in China) |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|