12-27-2015, 05:17 AM | #1 |
Registered
2
Rep 4
Posts |
Hi,
I ordered a M sport steering wheel (with Paddles) to install it on F20 LCI 118d (without paddles). Is there an additional harness needed to make the paddles work? Also, what is the coding procedure using E-Sys? Thanks in advance..! |
12-29-2015, 05:56 AM | #2 |
[HOONIGAN]
10
Rep 43
Posts |
I don't know anything about coding procedure but when doing the same retrofit on my pre-lci f20, i remember the shop added some kind of cable going from passenger's side to steering wheel to make the paddles work. And also you probably need a back cover for paddles to fit in if you don't want to drill a hole in yours.
__________________
When you feel like life is passing you by, downshift.
|
Appreciate
0
|
01-02-2016, 04:26 PM | #3 |
New Member
9
Rep 12
Posts |
so it is possible.
I was going to buy the steering wheel without paddles but now i might by the msport one with paddles. when you say drill holes what do you mean? is yours left hand or right hand drive? thanks |
Appreciate
0
|
01-03-2016, 10:48 AM | #4 |
[HOONIGAN]
10
Rep 43
Posts |
With some coding and the cable, yes, it is possible. Mine is left hand drive. By holes, i mean the space needed for the paddles to 'sit' in. You can see them in the attached picture of an m sport steering wheel's back cover. The hole in the red square.
__________________
When you feel like life is passing you by, downshift.
|
Appreciate
0
|
04-01-2016, 01:10 PM | #6 |
New Member
1
Rep 5
Posts |
If it helps i bought the steering wheel with paddles, I went to install the cabling but it was already in (2014 116d m-sport)
remove 205 add 2TB to the fa list and recode the whole SVT tree. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|